G76 Threading Cycle One-Line Format – Fanuc 10/11/15T Guide

Fanuc control models 10/11/15 use a one-line format for G76 threading cycle.

Fanuc G76 Threading Cycle One Line Format

Other Fanuc control models (0/16/18/20/21) use the double-block format for G76 threading cycle ( G76 Two-line format ).

The one-line format or single-block format of Fanuc canned cycles is older than two-line format.

In G76 threading cycle one-line format, the cycle uses the following data:

G76 X.. Z.. I.. K.. D.. A.. F.. P..

X : specifies the final thread diameter.

Z : is the position of the thread end.

I : specifies the amount of taper.

K : is the single thread depth.

D : is the depth of the first pass.

A : is the thread angle.

F : is the thread lead.

P : is the infeed method.

CNC Machine