DIN 1651 Grade 60SPb20 Cold Drawn Steel – High Strength & Machinability

The steel 16 MnCr 5 is used for larger parts with higher core strength and advantageous toughness properties in the vehicle and mechanical engineering (e.g. gears, shafts, steering parts). The lowest application amounts to -25 °C, the best application up to 50 mm nominal size.PropertiesGeneralProper

The steel 16 MnCrS 5 is used for larger parts with higher core strength and better machinability in the vehicle and mechanical engineering (e.g. gears, shafts, steering parts). The lowest application amounts to -25 °C, the best application up to 50 mm nominal size.PropertiesGeneralPropertyTemperatur

The steel 17 Cr 3 is used for high wear loaded smaller parts in the vehicle and mechanical engineering (e.g. camshafts, piston pins, cylinder). The lowest application amounts to -25 °C, the best application up to 25 mm nominal size.PropertiesGeneralPropertyTemperatureValueDensity20.0 °C7.82 g/cm³Mec

The steel 17 CrNiMo 6 is used for high loaded parts in the vehicle and mechanical engineering with high demands on toughness and core strength (e.g. gear parts, drive pinions). The lowest application amounts to -60 °C.PropertiesGeneralPropertyTemperatureValueDensity20.0 °C7.8 g/cm³MechanicalProperty